 In-mode combination process |
In-mode combination process Introduction
 |
1.Mold Preheating Clean the mold appliances and preheat the mold, then open the splint and the lid. |
 |
2.Place The Film Place IFFA In Mold Combination Film on bottom of the mold. |
 |
3.Fix The Film
Buckle the splint into the bottom, and check if the film fixed well. |
 |
4.Vacuum Turn on the suction device, and then the film will tightly close to the bottom in vacuum. |
 |
5.Pour PU Liquid
Pour PU Liquid into the mold, and then buckle the lid into the splint and the bottom. |
 |
6.Trim The Product
After the PU foaming, open the mold to take out the finished product and trim the spare film.
|
